Plumbing Tips

Chicago Combined Sewers and Basement Backups

November 14, 2026 · 11 min read · Rodding Rooter Chicago

If you’ve lived in Chicago for a few rainy seasons, you probably know someone with a basement story. A downpour comes through, the street floods for a bit and by morning a neighbor is hauling soaked boxes out to the curb. Maybe that someone is you.

The question we hear most is simple: why does this keep happening? The answer starts below the street, in a sewer system that was built for a different era. This guide explains how Chicago’s combined sewers work, why they lead to basement backups, what you can control and what you can’t.

We’re Rodding Rooter, and we’ve cleared drains and main lines around Chicago and its suburbs for more than 20 years. We’ll explain it the way we would to a neighbor, and we’ll point you to reliable sources for the bigger picture.

What “combined sewer” actually means

In a combined sewer system, one set of pipes carries two things: the wastewater from your home and the rainwater that runs off roofs, streets and yards. In a separate system, those two flows have their own pipes. Chicago, like many older American cities, built much of its system as a combined one.

According to reporting from WBEZ, most of Chicago’s sewer system predates 1930 and is a combined system. That’s long before modern storm patterns, paving and population were part of the plan.

On a dry day, a combined system works fine. The pipes carry a modest amount of household wastewater, and they have plenty of room. When a heavy storm hits, rain pours in from thousands of roofs and streets at once, and the pipes fill up fast.

Aerial view of a circular water treatment tank
Everything flushed or washed down in a combined system ends up at treatment, and heavy storms test the whole chain.

Why a full sewer pushes water into your basement

When a combined sewer fills, the water has to go somewhere. Water always finds the lowest opening, and in most homes the lowest opening is in the basement: a floor drain, a laundry tub, a basement toilet or a shower.

The same article notes that the Metropolitan Water Reclamation District’s modeling suggests the system can be overwhelmed after about two-thirds of an inch of rain in an hour. When the pipes are overwhelmed, pressure pushes water backward, including into basements.

Paved surfaces make it worse, because water can’t soak into the ground and instead runs straight into the sewer. More frequent heavy storms add to the strain. None of this is a failing on your part. It’s a system under pressure, and your house sits at the end of it.

Two different problems that look the same

Here’s something important that many people don’t realize. A basement backup in Chicago can come from two very different causes, and they need different fixes.

Problem one: a blocked private line

Your private sewer line runs from the house to the main in the street. If it’s partly blocked by roots, grease or debris, water backs up whenever the line has more than a trickle to carry. This can happen on a dry day, or during light rain. It’s a problem on your property, and it can be fixed by clearing the line with sewer rodding, and in some cases repairing it.

Problem two: a full city sewer

If the main in the street is full during a major storm, water can push back into your house even if your own line is perfectly clear. This is the combined-sewer problem, and a clear private line alone won’t prevent it.

Often, it’s both

In practice, many backups are a combination. A partly blocked line is the weak link that gives way when the street main is busy. That’s why the first step is usually to clear and inspect your own line. If backups continue, the other kind of protection comes into play.

Storm drain grate on wet pavement
Street drains and sewer mains carry both rain and household waste in a combined system.

What the city does

The same WBEZ article describes several things Chicago’s Department of Water Management and regional agencies do. It says the department has lined or replaced more than 750 miles of sewer mains in the past decade, and that restrictor valves are installed on most streets to temporarily hold water during storms. It also describes green infrastructure projects and an expansion of the regional Deep Tunnel system, with a fourth reservoir expected by 2029.

These efforts help, but they take time, and they don’t remove the need for homeowners to protect their own basements. We’d encourage you to read the original article and check the city’s own pages for the latest information, since projects and timelines change.

What you can do at home

Here’s what’s within your control, from simplest to most involved.

Keep your private line clear

This is the foundation. A line that’s free of roots, grease and debris handles surges better. If your line has a history of clogs, a camera inspection can show why. Our guide on the signs you need professional sewer rodding explains what to watch for.

Reduce the water going into the system

WBEZ notes ideas like disconnecting downspouts and using rain barrels. Directing roof water to a lawn or garden instead of the sewer reduces the load on the system during storms. Check local rules before making changes, since requirements differ by address.

Use less water during big storms

Holding off on laundry, the dishwasher and long showers while the sewer is under strain can help. It sounds small, but every gallon you keep out of the system is one the system doesn’t have to handle at that moment.

Consider a backflow device

The article describes a check or backflow valve installed in the private sewer pipe, which lets wastewater flow out but not back in. It’s usually installed by digging a pit in the front yard. It’s a job for a licensed plumber, and rules and permits apply.

Consider an overhead sewer

An overhead sewer is a bigger project. It raises the lowest drain in your basement and pumps wastewater to a pipe near the ceiling or first floor, so a full street main can’t force its way in. You can read more about the service on our overhead sewer conversion page, and our upcoming comparison of overhead sewers and backwater valves goes through the pros and cons.

A standpipe in a floor drain

WBEZ also mentions a standpipe, a large PVC pipe sealed to the basement floor drain to raise the drain opening above sewer level. It’s a simple measure, and it has trade-offs, so ask a plumber whether it suits your setup.

Cluttered room after water damage
The aftermath of a backup is costly and stressful. Prevention is usually cheaper than cleanup.

Why older homes feel it first

Some basements back up more than others, and age plays a role. In older Chicago neighborhoods, the combination of aging private lines, mature trees and a busy combined sewer is a tough one. A pipe that’s partly choked with roots can carry a quiet Tuesday’s worth of wastewater just fine, and fail the moment a storm adds a surge to the main.

Homes with finished basements, a basement bathroom or a laundry area are also more exposed, because they put fixtures at the lowest level, where a backup comes out first. That’s not a reason to avoid finishing a basement. It’s a reason to think about protection when you do, such as a backflow valve or overhead sewer installed by a licensed plumber.

It’s also worth knowing that where you live on the block can matter. Low-lying properties and homes at the bottom of a slope tend to see the effects sooner than those on higher ground. If your neighbors have had backups, don’t assume you’re safe just because yours hasn’t happened yet.

[img:651|Row of townhouses reflected in water|Block by block, the same sewer serves many homes, so what one house sees, the others often share.]

A simple storm-season checklist

If you’d like something practical to put on the fridge, here’s a short checklist for the rainy months.

  • Before the storm: clear the area around your cleanout, move valuables off the floor and make sure downspouts direct water away from the house.
  • During the storm: hold off on laundry and dishes, and avoid running extra water if the forecast is severe.
  • If drains start to bubble: stop using water right away and call for help before the water rises.
  • After the storm: check the basement, take photos of any damage and ask a professional to look at the line if you saw any warning signs.
  • Once a year: think about whether your line needs a cleaning or a camera look, especially if it has a history. Our post on how often to clean your sewer line can help.

You may also see alerts from regional agencies when heavy rain is expected. WBEZ’s article notes that the Metropolitan Water Reclamation District offers opt-in text notifications, which can be a useful reminder to limit water use before a big storm.

What to do when your basement drain backs up

If it happens, here’s the quick version.

  1. Stop using water. No laundry, dishwasher, showers or flushing.
  2. Keep people and pets out of any standing water.
  3. Be careful around electricity. Don’t step into water near outlets, appliances or a panel.
  4. Move valuables off the floor if it’s safe.
  5. Take photos for your records.
  6. Call a professional to check your private line. We answer emergency calls day or night.

Our guide on what to do when sewage backs up in your basement has more detail, and our post on why floor drains back up explains the common causes.

How to tell if the problem is your pipe or the city’s

This is the question everyone asks, and it deserves an honest answer. There isn’t a perfect test, but a few clues help.

  • It happens on dry days. That points to your private line.
  • It happens only in heavy storms, and the line was recently cleared and inspected. That points to the combined sewer.
  • Your neighbors have backups at the same time. That suggests a street-level problem.
  • A camera shows roots, buildup or damage. That’s your line, and it can be fixed.

The most reliable way to know is to have the line cleared and inspected. If it’s clear and healthy and backups continue in storms, you’ve learned something valuable, and you can look at flood protection without wondering if a clogged pipe was the real cause. We’d rather give you that answer honestly than sell you work that won’t solve it.

Who is responsible for what

As a general rule, the city looks after the sewer main in the street, and the owner looks after the private line from the building to the main. But the exact boundary can vary, and it isn’t always where people expect. There have been news reports of homeowners who paid a plumber and later learned the blockage was on city property. Before you commit to a big repair, it’s smart to confirm the boundary with the city. If your home is in a nearby suburb, your village’s public works department can do the same.

The cost question

People often ask what protection costs. We can’t give you a general number, because each home is different. Clearing a line is the smallest step. A backflow valve or overhead sewer is a bigger project that needs a licensed plumber and may need permits. Our guide to the average cost of sewer rodding explains what shapes estimates for rodding itself, and any larger project should come with a written estimate that explains exactly what’s included.

Get your Chicago line checked with Rodding Rooter

If your basement has backed up, or you’re worried about the next storm, call us at (773) 588-1200 or send a message. We’ll ask what you’re seeing, explain what to expect and give you an estimate before we start. Same-day service is often possible, and emergency calls are answered day or night.

Chicago’s combined sewers aren’t going away overnight. But a clear, well-understood private line, plus the right protection, can make the difference between a stressful storm and a ruined basement.

Chicago combined sewers: common questions

What is a combined sewer?

It is one set of pipes that carries both household wastewater and rainwater. Much of Chicago’s older system works this way, which means heavy storms can fill the pipes quickly.

Why does my Chicago basement back up when it rains?

When the sewer in the street fills during a storm, water can be pushed back into the lowest openings in a home. A partly blocked private line makes it more likely.

Will sewer rodding stop storm backups?

It helps if a blocked private line is part of the problem. If the street sewer is overwhelmed, a clear line alone may not prevent a backup, and extra protection may be needed.

What is the difference between a backflow valve and an overhead sewer?

A backflow valve is installed in the private line to stop water flowing back in. An overhead sewer raises the lowest drain and pumps wastewater up so it cannot back up through the floor drain.

Is the city responsible for my basement backup?

Usually the city handles the main in the street and the owner handles the private line. The boundary varies, so confirm it with the city before paying for a large repair.

What should I do during a heavy storm?

Limit water use, keep valuables off the basement floor and call a professional if drains begin to bubble or back up.